The original wiring schematics are included with the serial-number specific . Even though new Gordon Piatt burners were discontinued in , most parts. Quality replacement parts for Gordon-Piatt® burners. We stock blower wheels, cams, gas pilots, combustion heads, motors, electrodes, and other parts for your.
|Published (Last):||1 September 2011|
|PDF File Size:||20.94 Mb|
|ePub File Size:||11.26 Mb|
|Price:||Free* [*Free Regsitration Required]|
Gordon Piatt Burner Parts
Subscribe to this feed. It has a honeywell series control.
I’m glad it is low pressure. Is there a ground wire pulled into the burner from the electrical panel?
The time now is If not your talking to one now. Wires have good connection? Your pilot should be set to the lowest setting and still get ignition. Building Success with Routines and Rituals. I would verify all the grounding next, as you do not have many more parts to change. Getting Pumped for !
Training and Education Pro’s Forum: Sent from my iPhone using Tapatalk Make sure your gap is good on your ignitor. Good effort replacing the honeywell programmer. HVAC-Talk is proudly provided by: I agree A combustion analysis would provide good insight on what is going on.
Gordon piatt burners
It’s generally the last thing to fail intermittently. Uv scanner or flame rod?
I know it can be frustrating dealing with intermittent faults. I for sure, have had the problem of giving more gas! On the gordon piatt burner, Piaht have pulled the burner, and cleaned replaced the ignition, transformer, spark wire, and pilot valve and coil.
Do you have a service manager you could talk too about this? Looking for advise thanks Sent from my iPhone using Tapatalk.
I can show you how to put a end to these nuisance trips just need more info. Yordon a scanner, is it condensating on the end? There is not better place for the working men than the union! Thread Tools Show Printable Version. Last time I had intermittent faults like that, I found 5 wires that were not properly landed on the main terminal strip. Make sure your pilot isn’t getting too much gas.
All times are GMT Oil Burners Pro’s Forum: Last Jump to page: Get the model number and the fault code numbers. Do you have combustion analyzer? Power Quality Pro’s Forum: Also save that old flame safeguard control. For safety reasons what is your background with steam boilers?
Next time don’t replace the programmer for pilot faults or burner faults. Make sure everything is clean well secured and grounded. General Discussion Pro’s Forum: The Thrill of Exceeding Expectations. Gorcon, Regulators, Filters, Etc. Originally Posted by bcharlesm Not any help but that company started in my hometown. Related Forums The place where Electrical professionals meet. Building Science Discussions Pro’s Forum: Tug on all the wires to be sure they are tight.
They were underneath the screw clamps.
Free Gordon-Piatt Burner Manuals
Maybe piwtt a solenoid issue or regulator problem? The ground is good and, I’m getting a 5 on my flame signal, which is max out. Any new gas appliances? Last edited by ace; at Results 1 to 13 of Thread: