Page 1. Page 2. Page 3. Page 4. Page 5. Page 6. Page 7. Page 8. Page 9. Page Page Page Page Page Page Page Page Page your installer instruct you on system operation and on which features have Your security system is made up of a DSC PC or PC control panel, one or from having to manually bypass interior zones each time they wish to arm. Read this manual carefully and have your installer instruct you on system Your security system is made up of a DSC PC or PC control panel, one or.
|Country:||Republic of Macedonia|
|Published (Last):||16 December 2010|
|PDF File Size:||8.93 Mb|
|ePub File Size:||9.57 Mb|
|Price:||Free* [*Free Regsitration Required]|
Add to my manuals Add. Page of 16 Go.
Press [ ] to return to Ready. Memory Bypass Armed light will come ON indicating the system is armed. Page 10 Maintenance With normal use, the system requires minimum maintenance. This manual contains information on.
The metal cabinet contains the system electronics, fuses and instaallation battery. Don’t show me this message again.
DSC PC INSTALLATION MANUAL Pdf Download.
The smoke detectors may have been improperly installed Please Read Carefully or positioned. Light dusting with a barely damp cloth should remove normal accumulations of dust. An entry through any zone programmed as a installstion zone will create an instant alarm. Changes or modifications not expressly approved by Digital Security Controls Ltd. The entire manual should be carefully read.
Page 3 Master Code The 4 digit Master Code dwc used to arm and disarm the security system, to program additional security codes and to change other system features. All keypad entries mnaual made by pressing one key at a time. To print the manual completely, please, download it. Page 8 [P] Panic Holding this key down for two seconds causes a steady tone on your siren or bell if your installer has programmed this key for audible operation.
Entry Delay Off Arming If you wish to arm xsc system and eliminate the entry delay, enter [ ] before your access code. Don’t have an account? The Master Code will be supplied to you by your installer.
Got it, continue to print. PcPc – rev8Pc – rev8. Master Code The 4 digit Master Code is used to arm and disarm the security system, to program additional security codes and to change other system features.
PC – PC Security Products | DSC
Printed in Canada R Be sure to remove snow from exterior patio doors in winter; outdoor furniture or equipment should not block exits. Page 9 Ready light ON – System is ready for arming.
This manual also for: The control panel will be mounted out of the way in a utility closet installatiom in a basement. The alarm memory will automatically be displayed when the system is disarmed See Disarming the System. Maintenance With normal use, the system requires minimum maintenance.
An auxiliary warning device is also activated if your installer has connected installahion to your system. Do not wash the keypad with a wet cloth. By pressing ‘print’ button you will print only current page.
Smoke may not be able to reach the smoke detec- tors, such as when the fire is in a chimney, walls or roofs, or on Note to Installers the other side of closed doors. Press [ ] then  to display the zone which caused the alarm.
The following points should be observed.
rsc Comments to this Manuals Your Name. Page 4 Entry Delay Off Arming If you wish to arm your system and eliminate the entry delay, enter [ ] before your access code. Enter a valid access code to silence the alarm. Enter text from picture: Ready light ON – System is ready for arming.